Duplo DB-280 Manuel d'instructions télécharger pdf (Page 35)

~35~

4.4.3 Manual Mode

After the “STARTUP” procedures, the DB-280 will automatically set itself MANUAL operation and

flashing "LOAD BOOK" display. Note that the “NOTCH” LED is ON.

1

(1) Press the “OPEN” button and place the book block inside

the clamps. Be sure to follow the label instructions on the

clamp to load the book block to the RIGHT of the red line,

then slide the book block to the far LEFT of the clamps and

you will see the flashing "PUSH CLOSE" display.

Step 1:

Load book to the

RIGHT of the red line.

Step 2:

Slide the book to

The far LEFT.



(2) Then press the “CLOSE” button to clamp down the book

block and you will see the flashing "PUSH START" display.



Note:

In case you need to adjust the book block after you have closed

the clamps, you can press the "OPEN" button twice to release it.

The LED display will show "PUSH CLOSE". After you have

adjusted the book block, you have to press "CLOSE" button until

the clamps close. Then you will see the flashing "PUSH START"

display again.



(3) Press the “START” button. The LED display of control

panel will show a “Å” sign and the clamp station will move

over the notching station for notching.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 68 69

Pas de commentaire

Duplo DB-280 Manuel d'instructions Page 35